Table of Contents
Advertisement
Persistence : Superblock is persistent
Update Time : Tue Aug 15 18:31:09 2006
State : clean, degraded
Active Devices : 1
Working Devices : 1
Failed Devices : 0
Spare Devices : 0
UUID : 8a9f3d46:3ec09d23:86e1ffbc:ee2d0dd8
Events : 0.174164
Number
Major
0
0
1
8
The "Total Devices : 1", "Active Devices : 1", and "Working Devices : 1" indicate that only one of
the two devices is currently active. The RAID is operating in a "degraded" state.
The "Failed Devices : 0" might be confusing. This setting has a non-zero number only for that brief
period where the
driver finds a problem on the drive and prepares to remove it from the RAID.
md
When the failed drive is removed, it reads "0" again.
In the devices list at the end of the report, the device with the "removed" state for Device 0 indicates
that the device has been removed from the software RAID definition, not that the device has been
physically removed from the system. It does not specifically identify the failed device. However, the
working device (or devices) are listed. Hopefully, you have a record of which devices were members
of the RAID. By the process of elimination, the failed device is
The "Spare Devices : 0" indicates that you do not have a spare assigned to the RAID. You must
assign a spare device to the RAID so that it can be automatically added to the array and replace the
failed device.
6.5.3 Replacing a Failed Device with a Spare
When a component device fails, the
to the RAID. You can either keep a spare device assigned to the RAID as a hot standby to use as an
automatic replacement, or assign a spare device to the RAID as needed.
IMPORTANT: Even if you correct the problem that caused the problem disk to fail, the RAID does
not automatically accept it back into the array because it is a "faulty object" in the RAID and is no
longer synchronized with the RAID.
If a spare is available, md automatically removes the failed disk, replaces it with the spare disk, then
begins to synchronize the data (for RAID 1) or reconstruct the data from parity (for RAIDs 4 or 5).
If a spare is not available, the RAID operates in degraded mode until you assign spare device to the
RAID.
Minor
RaidDevice State
0
0
removed
18
1
active sync
driver replaces the failed device with a spare device assigned
md
/dev/sdb2
.
/dev/sda2
Managing Software RAIDs with EVMS
89
Advertisement
Table of Contents
Troubleshooting
