Configuring Bcc Software; Installing The Bcc Identity Manager Templates - Novell BUSINESS CONTINUITY CLUSTERING 1.2 - ADMINISTRATION Administration Manual

4.4.2 Configuring BCC Software

Perform the following tasks for each of the nodes in every peer cluster:
1 Log in as the
2 Use one of the following methods to open the BCC Configuration page:
In YaST, select Miscellaneous > Novell-BCC.
At a terminal console prompt, enter
yast2 novell-bcc
3 When prompted to Install Core Business Continuity Clustering Software and Configure Core
Software, click Yes to install and configure the BCC software.
4 Click Continue if you are prompted to configure LDAP.
5 In the eDirectory Tree dialog box, specify the eDirectory Administrator user password that you
used when you installed the operating system, then click OK.
6 Specify the typeful fully distinguished eDirectory name for the cluster where the server is
currently a member.
7 Select Start BCC services now to start the software immediately following the configuration
process.
If you deselect the check box, you must manually start BCC services later by entering the
following at the terminal console prompt:
rcnovell-bcc start
8 Specify the Directory Server Address by selecting the IP addresses of the master eDirectory
server and the local server.
9 Accept or change the eDirectory Administrator user name and specify the Administrator user's
password.
10 Click Next.
11 Review your setup on the Novell Business Continuity Clustering Configuration Summary
page, then click Next to install the BCC software.
12 Click Finish to save the BCC configuration and exit the tool.
13 Verify that the BCC software is running on the server by entering the following at a terminal
console prompt:
rcnovell-bcc status
14 Continue with

4.4.3 Installing the BCC Identity Manager Templates

The Identity Manager management templates for Business Continuity Clustering consist of XML
templates for the eDirectory driver that are used for synchronizing objects between peer clusters.
The templates are required to configure your business continuity cluster. You must have previously
installed iManager on the server where you plan to install the templates.
You should install the management templates on the same server where you installed the Identity
Manager Management utilities. For information, see
Edition," on page
52 BCC 1.2: Administration Guide for OES 2 SP1 Linux
user on the server.
root
Section 4.4.3, "Installing the BCC Identity Manager Templates," on page
42.
Section 4.1.7, "Identity Manager 3.6 Bundle
52.