Installing And Configuring The Novell Business Continuity Clustering Software - Novell BUSINESS CONTINUITY CLUSTERING 1.2 - ADMINISTRATION Administration Manual

2 Find either of the following lines:
ncsgroup:!:107:
or
ncsgroup:!:107:bccd
The file should contain one of the above lines, but not both.
3 Depending on which line you find, edit the line to read as follows:
ncsgroup:!:107:bccadmin
or
ncsgroup:!:107:bccd,bccadmin
4 Replace bccadmin with the BCC Administrator user you created.
Notice the group ID number of the
actual number is the same on each node in a given cluster; it might be different for each cluster.
5 After saving the
For example, if you named the BCC Administrator user
The
ncsgroup
4.4 Installing and Configuring the Novell
Business Continuity Clustering Software
It is necessary to run the Novell Business Continuity Clustering installation program when you want
to:
Install and configure Business Continuity Clustering engine software on the cluster nodes for
the clusters that will be part of a business continuity cluster.
The Business Continuity Clustering for Linux installation installs to only one server at a time.
You must install it on each node of each cluster that you want to be part of a business continuity
cluster.
Install the BCC-specific Identity Manager templates for iManager on an OES 2 Linux server
where you have installed iManager.
The templates add functionality to iManager so you can manage your business continuity
cluster. You must have previously installed iManager on the server where you plan to install the
templates.
Uninstall Business Continuity Clustering software.
IMPORTANT: Before you begin, make sure your setup meets the requirements specified in
Section 4.1, "Requirements for BCC 1.2 for OES 2 SP1 Linux," on page
Administrator user and group must already be configured as specified in
BCC Administrator User and Group," on page
You must install the Business Continuity Clustering engine software on each cluster node in each of
the peer clusters that will be part of a business continuity cluster. You install the software on the
nodes of one cluster at a time.
50 BCC 1.2: Administration Guide for OES 2 SP1 Linux
ncsgroup
file, execute the
/etc/group
should appear as a secondary group of the BCC Administrator user.
. In this example, the number 107 is used. The
command from a shell.
id
, enter
bccadmin
48.
.
id bccadmin
37. The BCC
Section 4.3, "Configuring a