Viii - After-Sales Operations, Accessories - CITROEN XSARA Technical Training Manual

VIII - AFTER-SALES OPERATIONS, ACCESSORIES

A - GENERAL
In the factory, an initialisation procedure is performed at the end of vehicle
assembly in order to allow the various devices to recognise each other:
• ignition key with integrated transponder and BSI,
• HP remote controls and BSI,
• engine management ECU and BSI,
• radio and BSI.
B - ACCESSORIES
All new devices which have not undergone a programming procedure are not
recognised by the system and are therefore not operational. It is therefore
essential to declare all accessories which are added to or removed from the
vehicle. All programming procedures require the use of a diagnostic tool. They
must be performed on the vehicle.
Note: The multiplexed self-powered alarm must be disconnected when
performing a diagnostic procedure on the vehicle.
XSARA PICASSO CD changer
XSARA
C - CUSTOMISATION OF CERTAIN FUNCTIONS
Upon the customer's request, the BSI can be programmed to activate the
function or not.
Radio volume linked to vehicle speed: Programming of the radio.
MULTIPLEXED BSI - XSARA PICASSO AND XSARA – PART 1
© AUTOMOBILES CITROËN Toute reproduction ou traduction même partielle sans l'autorisation écrite d'AUTOMOBILES CITROËN est interdite et constitue une contrefaçon
24
ACCESSORIES
YES > Programming of the control
panel
Alarm YES > Deactivation of signalling when
locking: BSI programming
Accessory alarm YES
deactivation of signalling when locking
PROGRAMMING IF
ADDING/REMOVING
> BSI programming
Chapter 2
+