CITROEN XSARA Technical Training Manual page 207

D - SPECIFIC OPERATIONS
IMPORTANT: When fitting an after-sales alarm, the BSI must be
Opening the vehicle with the key:
If the vehicle is opened using the key, the alarm is triggered. To disarm the
alarm, the following procedure must be performed: enter the "EMERGENCY
CODE".
Entering the "EMERGENCY CODE":
A 5 figure code is given on a card supplied with the alarm system. Example:
43125.
STEP
1
2
3
4
5
6
Repeat the procedure from step 2 to step 6 for the other 4 figures. If the code
is recognised, the alarm is disarmed.
MULTIPLEXED BSI - XSARA PICASSO AND XSARA – PART 9
© AUTOMOBILES CITROËN Toute reproduction ou traduction même partielle sans l'autorisation écrite d'AUTOMOBILES CITROËN est interdite et constitue une contrefaçon
programmed to prevent the indicators from being controlled
when the doors are locked/unlocked. In this case, the alarm
controls signalling.
ACTION
Open the door.
Switch on the ignition.
Switch off the ignition immediately.
Switch on the ignition immediately.
Allow the LED to flash 4 times (1
the code).
Switch off the ignition.
189
st
figure of
Chapter 3
EFFECT
The siren is set off.
The siren stops.