Gigabyte GSmart i User Manual page 8

You can input your personal information to the device in Owner Information.
1.Tap " Start " > Settings > Personal Tab >
2.Tap on " Name " field and input your name.
3.Tap on a desired input field and input your information.
4.Tap on the Notes tab to input other information you would like to display on your device.
5.If you want your information to be displayed on the starting screen, tap on the Options
tab, and check both " Identification Information "and " Note ".
6.Select " OK " to finish setup and save it.
You can set your own password to prevent unauthorized use of your device.
1.Tap " Start " > Settings > Personal Tab >
2.On Password tab screen, check " Prompt if device unused for ".
3.Select an appropriate time.
4.Select a password type in " Password Type " field.
5.Input your password in the " Password " field and reconfirm the password in " Confirm".
6.Tap " OK ", a pop - up window will appear to confirm " Do you want to save password
settings changes?".
7.Tap " Yes " to finish settings and save the changes; " No " to cancel.
8.You may also input password hint message under the Hint tab screen.
9.Tap " OK " to save your inputs.
Note: If you forget your password, you need to perform system default, which will lose
all your data and settings.
On " Today " screen, tap { Device unlocked } to lock your device. When the device is
locked, the device will not respond to touches on screen nor will it react to any input on the
keypad.You can enable device lock after entering Sleep mode by pressing the power key.
To enable this setting, please follow the steps below:
14
Owner Information > Identification Tab.
Lock > Password Tab.
˙Tap " Start " > [Programs] > Phone Applications > Settings Tab.
˙Check "Lock device when in sleep mode".
Unlock device:
1.Tap { Unlock } on the bottom left of the screen, or press the left function key.
2.Tap the { Unlock } button on the newly appeared screen and the device is unlocked.
Reboot System:
When you reboot the device, all running programs will stop and you will lose all unsaved
information. Please make sure that all information has been saved before performing
system reboot.
1.Reset key is located on the bottom right side of your device.
2.Use the stylus to softly poke the reset key on the lower right side of the device to reboot
your system.
System Reset:
When executing system reset, you are performing a clean boot on the device. It will remove
the programs you have installed on this device, and reset all settings and information back
to factory defaults.
1.Turn off the device.
2.Press the Call key and End key at the same time, and press power key while still
holding Call key and End key.
3.This device will restore to system defaults and reboot.
To avoid damaging your device screen and camera lens, please do not drop, smash, or
place pressure on the device.
15