JETWAY V333DAR2A User Manual page 12

2. CPU Front Side Bus Frequency Setting (2-pin) : JP4
Note: CPU Front Side Bus Frequency also can setting step by step in BIOS
SETUP, please refer page
Next.
3. CMOS RAM Clear (3-pin) : JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below:
1. Turn off the system and unplug the AC power
2. Remove ATX power cable from ATX power connector
3. Locate JBAT and short pins 2-3 for a few seconds
4. Return JBAT to its normal setting by shorting pins 1-2
5. Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
4. Keyboard Power On function Enabled/Disabled: JP1
When setting Enabled you can using keyboard by key in password to power on
system.
1
2
JP4
ON :
100MHz/200MHz
CPU Front Side Bus Frequency Setting
35 Miscellaneous Control in Host Clock at
1 3
JBAT
1-2 closed Normal
CMOS RAM Clear Setting
8
1
2
JP4
OFF :
133MHz/266MHz
1 3
JBAT
2-3 closed Clear CMOS