Install Memory - JETWAY K8M8MSR1A User Manual

2-4 Install Memory

This motherboard provides
(DIMM) sites for DDR memory expansion available from minimum memory size of 64MB to
maximum memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM)
Total
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-pin DDR SDRAM module looks like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 200MHz, use only DDR400- compliant
DDR Modules. When this motherboard operate at 200Mhz, most system will
not even boot if non-compliant modules are used because of the strict
timing issues, if your DDR Modules are not DDR400-compliant, set the
SDRAM clock to 133MHz to ensure system stability.
two 184-pin DDR DUAL INLINE MEMORY MODULES
184-pin DDR DIMM
DDR266/DDR333/DDR400 DDR DRAM
Module
DDR266/DDR333/DDR400 DDR DRAM
Module
System Memory (Max. 2.0GB)
DIMM2 (BANK2+BANK3)
DIMM1 (BANK0+BANK1)
9
PCS Total Memory
X1 64MB∼1.0GB
X1 64MB∼1.0GB
X2 64MB∼2.0GB
Figure 2-4