Table of Contents
Advertisement
2-4 Install Memory
This motherboard provides
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1) DDR200/DDR266
Bank 2, 3 (DDR2) DDR200/DDR266
Total
NOTE!
Make sure the installed memory are DDR266 SDRAM support 133MHz
memory clock, otherwise the system may hang during startup.
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can
refer to figure 2-4 to see what a 184-Pin DDR266/DDR200 DDR SDRAM module looks
like.
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-
compliant DDR Modules. When this motherboard operate at 133Mhz,
most system will not even boot if non-compliant modules are used because
of the strict timing issues, if your DDR Modules are not DDR266-
compliant, set the DDR SDRAM clock to 100MHz to ensure system
stability.
two
184-pin DUAL INLINE MEMORY MODULES (DIMM)
184-Pin DIMM
DDR SDRAM Module
DDR SDRAM Module
System Memory (Max. 2.0GB)
10
Total Memory
X1
64MB∼1.0GB
X1
64MB∼1.0GB
2
64MB∼2.0GB
Figure 2-4
Advertisement
Table of Contents
