Hawking HDWABN1 Manual page 17

7. Screw the body (2) to the Ethernet connector of the Hi-Gain Outdoor
Wireless-N Access Point.
Power Installation
1. Connect one end of the Ethernet cable to the LAN port of the Hi-Gain
Outdoor Wireless-N Access Point, and the other end of the Ethernet
cable to the port labeled 'Power+DATA OUT' on the Power Over
Ethernet Power over Ethernet DC Injector.
2. Connect another Ethernet cable from the port labeled 'LAN' on the
Power Over Ethernet Power over Ethernet DC Injector to your
router/switch or to a PC.
3. Connect the power adapter to the connector on the Power over
Ethernet DC Injector.
4. Connect the power cord to the power adapter and into an electrical
outlet.
Note: You must use the power adapter shipped along with the Hi-Gain
10