Installation Instructions - Asko T741 Use And Care Manual

INST INSTALLA INST ALLATION INSTR ALLA ALLA TION INSTR TION INSTRUCTIONS TION INSTR
INST INST ALLA TION INSTR
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
SPECIFICA SPECIFICA TIONS TIONS
SPECIFICATIONS SPECIFICA SPECIFICA TIONS TIONS
Height 33-1/2"–34-1/2 (850–876 mm)
Width 23-7/16" (595 mm)
Depth 24-7/16" (620 mm)
Weight 86 lbs (39 kg)
Drum material Stainless Steel
Outer casing Stove-enamelled hot-dipped
galvanized steel
CONDENSA CONDENSA CONDENSA CONDENSATION DRAIN CONNECTION CONDENSA TION DRAIN CONNECTION TION DRAIN CONNECTION TION DRAIN CONNECTION TION DRAIN CONNECTION
Install the dryer so the condensed water will
continuously flow into a drain or sink. To do this, follow
the instructions below:
1. Disconnect the short hose (1) from the blue
connection. (It's okay to let the hose hang down.)
2. Connect the rubber hose supplied with the dryer to
the blue nipple (2).
3. Run the hose to a drain or sink, as illustrated.
NOTE: The drain hose must not be more than 40"
above the floor.
LEVELING LEVELING LEVELING THE MA THE MA THE MACHINE THE MA
LEVELING LEVELING THE MA
It is important that the machine is level. Each foot on the
dryer is adjustable, so you can level the unit on any
surface. Once it is level, securely tighten the lock nuts
on the feet.
Page 4
UCTIONS UCTIONS UCTIONS
UCTIONS
CHINE CHINE CHINE
CHINE
NOTE: Cosmetic damage must be reported to your
dealer within five days from the date of pur-
chase. After unpacking the dryer, thoroughly
check the unit for cosmetic damage.
Power requirement 2800 watts
For connection Single-phase, 230 V, 30 Amp
Heating element 2500 watts
1
3
Back of dryer
2
3
Be sure to tighten the
lock nuts securely
when you level the
machine.