Asko T741 Use And Care Manual page 6

CONNECTING A 3-WIRE POWER CORD
WARNING!
Before starting this procedure, be sure the
power is turned off at the breaker/fuse box.
Power Supply Cord
You will need a 3-wire power supply cord with three No.
10 copper wires and a matching 3-wire receptacle of
NEMA Type 10-30R, as illustrated below:
Ground
CONNECTING A 4-WIRE POWER CORD
WARNING!
Before starting this procedure, be sure the
power is turned off at the breaker/fuse box.
Power Supply Cord
You will need a 4-wire power supply cord with four No.
10 copper wires and a matching 4-wire receptacle of
NEMA Type 14-30R, as illustrated below. The fourth wire
must be identified with a green cover and the neutral
conductor by a white cover.
Page 6
To connect a 3-wire power cord to the dryer, follow the
steps below.
NOTE: The numbers in the illustration below corre-
late to the step numbers.
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal
block opening.
4. Loosen or remove
center
block screw.
5. Connect ground
(middle ) wire of
power supply cord
to the center, silver-
colored terminal
screw.
screw.
6. Connect the other
Ground
wires
Middle
screws.
7. Tighten the strain
relief screws.
8. Replace terminal box cover on back of dryer.
9. Plug dryer into wall receptacle.
10. Turn power on at breaker/fuse box.
To connect a 3-wire power cord to the dryer, follow the
steps below.
NOTE: The numbers in the illustration below corre-
late to the step numbers.
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal
block opening.
4. Remove
terminal block screw.
5. Remove ground wire
(green with yellow
stripes) from external
ground
screw. Fasten under
center, silver-colored
terminal block screw.
6. Connect
(green) wire of cord to
external
conductor screw.
7. Connect neutral (white)
wire of cord under
center screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10. Replace terminal box cover on back of dryer.
11. Plug dryer into wall receptacle.
12. Turn power on at breaker/fuse box.
terminal
6
Tighten
7
to outer
center
5
6
connector
7
ground
8
ground
4
5
4
9