Table of Contents
Advertisement
NETGEAR Managed Switches Software Administration Manual, Release 8.0
b. Under CST Port Configuration, scroll down to interface 1/0/3 and select the checkbox for that
interface. Now 1/0/3 appears in the Interface field at the top.
c.
In the CST Port Configuration, select Enable in the Port Mode field.
d. Click Apply
Configure Rapid STP (802.1w)
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configuring Rapid STP (802.1w)
(Netgear switch) (Config)# spanning-tree
(Netgear switch) (Config)# spanning-tree forceversion 802.1w
(Netgear switch) (Interface 1/0/3)# spanning-tree port mode
Web Interface: Configuring Rapid STP (802.1w)
To use the Web interface to configure the managed switch, proceed as follows:
1.
Enable the 802.1w on the switch
a.
From the main menu, select Switching > STP > STP Configuration. A screen similar to the
following displays.
Figure 25-3
b. Enter the following information in the STP Configuration.
•
Next to the Spanning Tree Admin Mode, select the Enable radio button.
25-3
v1.0, October 2009
Spanning Tree Protocol
Advertisement
Table of Contents
