Installation - VINCENT SP-T100 Instructions For Use Manual

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Contacting the middle pin of the RCA plugs with
the outer ring of the RCA chassis jack may lead to
damages to the main amplifier if it is switched on!
To avoid this hazard, connect or disconnect only
in switched-off state and more than one minute
after deactivating!
Speaker cable connections
The use of ready-made loudspeaker cables is recom-
mended instead of connecting the cable's central
wire (strand) directly to the terminals. Banana plugs
or cable lugs ensure high security from short-circuits
and damage to loudspeakers or amplifier.
Ensure that bare loudspeaker wires are never able
to come into contact with each other or with the
metal on the back of the housing.
Make sure that the positive and negative loud-
speaker wires are connected correctly. You will
notice a reduced sound quality if the connections
are the wrong way round.
Only use loudspeakers with a nominal impedance
of at least 4Ω.

INSTALLATION

DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1 2 BALANCE
O U T P U T
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
Vincent
23