Chipset Features Setup - TYAN TOMCAT I II Manual

w w Security Option
This category allows you to limit access to the system setup, or just
setup. Default value is Setup
System The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt
Setup The system will boot, but access to setup will be denied if the
password is not entered at the prompt
w w PS/2 Mouse Function
Enables or disables PS/2 mouse function. Default is Disabled.
w w PCI/VGA Palette Snooping
The purpose of this option is to allow multiple VGA devices on
different busses in a system to have data written from CPU to each
set of palette registers of every video device. Default is disabled.
w w Video BIOS Shadow
It determines whether Video BIOS will be copied to RAM, however, it
is an optional chipset design. Default is Enabled.

4.7 Chipset Features Setup

This screen controls the settings for the board's chip set. The controls for
this screen are the same as the previous screen.
The Chipset Features Screen
DRAM RAS# Precharge Time :4
DRAM R/W Leadoff Timing
Fast RAS# To CAS# Delay
DRAM Read Burst Timing
DRAM Write Burst Timing
DRAM Speculative Leadoff
Turn-Around Insertion
System BIOS Cacheable
Video BIOS Cacheable
8 bit I/O Recovery Time
16 bit I/O Recovery Time
Memory Hole at 15M/16M
IDE Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
S1562-001-01
ROM ISA BIOS
CHIPSET SETUP UTILITY
AWARD SOFTWARE, INC.
PCI Slot IDE 2nd Channel
:7/6 Peer Concurrency
Chipset Special Features
:3
:x4444 DRAM ECC/Parity Select
:x4444
:Disabled Onboard FDC Controller
Onboard Serial Port 1
:Disabled
Onboard Serial Port 2
:Enabled Onboard Parallel Port
Parallel Port Mode
:Enabled
:1
:1
:Disabled
:Disabled
:Auto
ESC :Quit
:Auto
:Auto
F1 :Help
:Auto
F5 :Old Values (Shift)F2 :Color
:Enabled
F6 :Load BIOS Defaults
:Enabled
F7 :Load Setup Defaults
33
:Enabled
:Disabled
:Disabled
:Parity
:Enabled
:Com1/3F8
:Com2/2F8
:378/IRQ7
:Normal
:Select Item
PU/PD/+/- :Modify