Desa Comfort Glow RFP28TC Owner's Operation And Installation Manual page 5

ASSEMBLY
Continued
Assembling and Attaching
Brass Trim
1. Remove packaging from three remain-
ing pieces of brass trim.
2. Locate four brass screws, two adjust-
ing plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as
shown in Figure 6.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top brass trim
(see Figure 6).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side brass
trim (see Figure 6).
6. While firmly holding edges of brass
trim together, tighten both set screws
on the adjusting plate with slotted
screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Place the assembled trim on front of
heater cabinet. Attach on top and sides
with four brass screws included in hard-
ware package (see Figure 7).
9. Reattach front panel to heater if you are
going to mount the heater to the base.
Do not reattach front panel at this time
if you are going to mount heater to wall.
103509
Set Screws
Side
Brass
Adjusting
Trim
Plate
Shim
Mitered Edge
Slot
Figure 6 - Assembling Brass Trim
Screws
Figure 7 - Attaching Brass Trim to Heater
5
OWNER'S MANUAL
Top
Brass
Trim
Slot
Assembled
Brass Trim