Table of Contents
Advertisement
INSTALLATION
Continued
Front
Log (#1)
Figure 25 - Installing Crossover Log #6
(CCL3924PTA/NTA Shown)
Single Burner Seasonal Oak Models
CRL2718PA/NA, CRL3124PA/NA
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
The Seasonal Oak Log Set is a reversible log
set. This means that the 2 bottom logs may be
turned to face either direction. The top logs,
however, must remain in the same position.
Do not modify logs. Only use logs supplied
with heater.
1. Place back log onto back of base assembly.
Make sure log sits forward against 2 posts
in front of log (see Figure 26). This log may
be turned to face either direction.
2. Place front log onto grate on front of base
assembly. The log will fit down between
grate fingers and posts on front of base
assembly (see Figure 27). This log may
be turned to face either direction.
3. Place left and right crossover logs on top of
back log and front log. Make sure pins on
front and back are inserted into holes on
crossover logs (see Figure 28). Crossover
logs must be placed as shown in Figure 28
or holes will not seat onto pins.
4. Add lava rock around base of heater if
desired. Do not put lava rock on logs or
burner.
18
Base
Crossover
Assembly
Log (#6)
Pins
Middle
Log (#2)
Left Crossover Log
www.desatech.com
Post
Figure 26 - Installing Back Log
Post
Grate
Fingers
Base
Assembly
Figure 27 - Installing Front Log
Figure 28 - Installing Left and Right
Crossover Logs
Back Log
Post
Front Log
Post
Right
Crossover Log
113097-01L
Advertisement
Table of Contents
