Administration > Diagnostics; Administration > Factory Defaults - Linksys WRT54G3GV2-ST - Wireless-G Router For Mobile Broadband Wireless User Manual

Chapter3
Log
Type Select Incomng Log, Outgong Log, Securty
•
Log, or DHCP Clent Log.
• <Type> Log The Incoming Log will display a
temporary log of the source IP addresses and
destination port numbers for the incoming Internet
traffic. The Outgoing Log will display a temporary
log of the local IP addresses, destination URLs/IP
addresses, and service/port numbers for the outgoing
Internet traffic. The Security log will display the login
information for the web-based utility. The DHCP
Client Log will display the LAN DHCP server status
information.
Click Save the Log to save this information to a file
on your PC's hard drive. Click Refresh to update the
log. Click Clear to clear all the information that is
displayed.
Click Save Settngs to apply your changes, or click Cancel
Changes to cancel your changes.
Administration > Diagnostics
The diagnostic tests (Ping and Traceroute) allow you to
check the connections of your network devices, including
connection to the Internet.
Administration > Diagnostics
Diagnostics
Ping Test
The Ping test checks the status of a connection.
IP or URL Address Enter the address of the PC whose
connection you wish to test.
Packet Sze Enter the packet size you want to use. The
default is 32 bytes.
Tmes to Png Enter many times you wish to test it.
Start to Png To run the test, click this button. The Ping
Test screen will show if the test was successful. Click Close
to return to the Diagnostics screen. Click Stop to end the
test.
Wreless-G Router for Moble Broadband
Advanced Configuration
Diagnostics > Ping
Traceroute Test
The Traceroute test tests the performance of a
connection.
IP or URL Address
Enter the address of the PC whose
connection you wish to test.
Start to Traceroute To run the test, click this button. The
Traceroute Test screen will show if the test was successful.
Click Close to return to the Diagnostics screen. Click Stop
to end the test.
Diagnostics > Traceroute
Administration > Factory Defaults
The Administration > Factory Defaults screen allows you
to restore the Router's configuration to its factory default
settings.
Administration > Factory Defaults
NOTE:
Do not restore the factory defaults unless
you are having difficulties with the Router and
have exhausted all other troubleshooting
measures. Once the Router is reset, you will have
to re-enter all of your configuration settings.
2