Stove Cavity Assembly - Desa SVYD18NRA/PRA SERIES Owner's Operation And Installation Manual

Unvented (vent-free) gas stove heater
Table of Contents

Advertisement

INSTALLATION
Continued
12"
Minimum
Side
Wall
12
"
Minimum
Side Wall
Top View
Corner
Wall
Wall
6
"
Minimum
Front of
Stove Unit
Figure 4 - Minimum Clearance to Walls
and Ceiling (Stove May Vary Depending
on Model)

STOVE CAVITY ASSEMBLY

1. Lift off corrugated box enclosing stove body
crating.
2. Remove all screws fastening the wood frame
enclosure. Spread wood frame open and lift
away from plastic-bagged stove body. The
bottom pieces of pallet wood will remain
bolted to the stove body.
3. Remove plastic bag from stove body.
113084-01A
Ceiling
Front
48"
View
Minimum
12"
Minimum
Side
Wall
Back Wall
6
"
Minimum
12
"
Minimum
Front of
Stove Unit
6
"
Minimum
Ceiling
Side
View
48"
Minimum
6"
Minimum
Floor
www.desatech.com
4. Remove all contents from inside stove cavity.
Contents include:
(4) - Legs (include leg leveler bolts)
(1) - Bottom door
(3) - Top grates
(1) - Hardware kit bag with fasteners
5. Carefully lay stove body on back to attach
bottom components to stove body (see Fig-
ure 5). Rest stove on drop cloth or blanket to
avoid scratching stove edges.
6. Remove remaining pallet wood attached to bot-
tom of stove body (see Figure 6). Use an adjust-
able wrench or 12mm socket to remove bolts.
7. Fasten each leg to stove with four (4) M8 x
1.25 - 20mm bolts. Use a flat washer and lock
washer with each bolt. Tighten bolts into
Side Wall
threaded holes on stove body (see Figures 7
and 8, page 10). Use an adjustable wrench or
a 12mm socket.
8. Attach stove door by inserting step bolt
through door hinge pivot hole and into
threaded hole in stove body (see Figure 7 and
Figure 10, page 10). Use an adjustable wrench
or a 12mm socket to fasten step bolt. Tighten
step bolt until snug. Make sure door moves
freely.
Top of
Stove Unit
Front of
Stove
Back
Wall
Unit
Drop
Cloth/
Blanket
Figure 5 - Laying Down Stove On Side
(Stove Style May Vary Depending on
Bolt
Pallet Wood
Figure 6 - Removing Pallet Wood From
The Bottom of The Stove
Front of
Stove Unit
Pallet Wood Bolted to
Stove Body Bottom
Model)
Front
Top of
Stove
Unit
Pallet
Wood
Bottom
Of Stove
Unit
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Svyd18nra seriesSvyd18pra series

Table of Contents