Table of Contents
Advertisement
DESA INTERNATIONAL
VENT-FREE NATURAL GAS STOVE HEATER
INSTALLATION
Continued
STOVE CAVITY ASSEMBLY
1.
Lift off corrugated box enclosing stove
body crating.
2.
Remove all screws fastening the wood
frame enclosure. Spread wood frame
open and lift away from plastic-
bagged stove body. The bottom pieces
of pallet wood will remain bolted to
the stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see
Figure 5). Use an adjustable wrench or
a 10 mm socket. Remove six (6) bolts
and washers. Keep bolts and washers
to reattach back panel later.
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom
(4) - Legs (Amity and Townsend
models include leg leveler bolts)
(1) - Bottom door
(1) - Top grate
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to
attach bottom components to stove
body (see Figure 6). Rest stove on drop
cloth or blanket to avoid scratching
stove edges.
7. Remove remaining pallet wood at-
tached to bottom of stove body (see
Figure 7). Use an adjustable wrench to
remove bolts.
Bolt
Product
Back Stove Panel
Identification Label
Figure 5 - Removing Back Panel
Top of Stove Unit
Front of
Stove Unit
Drop Cloth/
Blanket
Figure 6 - Laying Down Stove On Side (Stove Style May Vary Depending on Model)
Bolt
Pallet
Wood
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
8
Front of
Stove Unit
Pallet Wood
Bolted to
Stove Body
Bottom
Front
Top of
Stove
Unit
Pallet
Wood
Bottom Of
Stove Unit
104461
Advertisement
Table of Contents
