Cast Iron Stove And Direct-Vent Burner System Assembly - Desa (F)SDVBNC Owner's Operation And Installation Manual

PRE-INSTALLATION
PREPARATION
Continued
3. Proper clearances must be maintained, see Figures 3 and 4.
4. This stove is a freestanding unit designed to set directly on the
floor. If your stove is to be installed directly on carpeting, vi-
nyl tile, or any combustible material other than wood, it must
be installed on a metal or wood panel extending the full width
and depth of the stove. See Figure 5.
36"
from
Front
Floor
6
"
Figure 3 - Clearances for Standard Installation
4"
Figure 4 - Clearance for Corner Installation
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107304

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY

Ceiling
42"
4"
from
Back
27"
Wall
29"
4 "
Front
4"
PRE-INSTALLATION PREPARATION
Location and Space Requirements (Cont.)
Stove Body Assembly (Cont.)
19 1 / "
2
Figure 5 - Stove With Burner System Bottom Dimensions
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
STOVE BODY ASSEMBLY
1. Lift off corrugated box enclosing stove body crating.
2. Remove all screws fastening the wood frame enclosure. Spread
wood frame open and lift away from plastic-bagged stove body.
The bottom pieces of pallet wood will remain bolted to the
stove body.
3. Remove plastic bag from stove body.
4. Locate the product identification label on the back panel (see
figure 6) and record the model number and 7 digit serial num-
ber in the space provided in the back of this owner's manual.
Retain this operation and installation manual for future refer-
ence and warranty.
5. Remove the six (6) bolts on the back stove panel with an ad-
justable wrench or a 10 mm socket. Discard the back panel
and retain the bolts and washers to attach the rear cover pro-
vided with the burner system.
Bolt
Back Stove
Panel
Figure 6 - Removing Back Panel
1
26 / "
4
Front
Product
Identification
Label
5 5