Table of Contents
Advertisement
How should the SCSI bus be terminated?
Description
It is unclear if the bus is already terminated
or where an additional terminator should
be placed.
Is the correct SCSI host bus adapter installed?
Description
The server already has a SCSI host bus
adapter but it is difficult to determine what
type it is.
The server may not have a SCSI host bus
adapter installed.
38
Further information
Both ends of a SCSI bus must be terminated.
Typically, when connecting an internal drive to the
ribbon cable already inside your server then both the
host bus adapter and the end of the ribbon cable will
already be terminated and no further action is
required.
Refer also to the "SCSI Configuration" section in the
online User's Guide on the HP StorageWorks Tape
CD-ROM.
Further information
If your server is in its original configuration (no SCSI
adapters have been added or removed) then use
www.hp.com/go/connect to check the
compatibility of your system. You can also check the
SCSI configuration from the boot-up screen or from
the Windows Control Panel, or by using HP Library &
Tape Tools (see page 33).
Use HP Library & Tape Tools (see page 33) to check
whether you have a SCSI host adapter on your
system. If not, you will need to purchase one. Refer to
the ordering supplies section in the online User's
Guide on the HP StorageWorks Tape CD-ROM.
Advertisement
Table of Contents
