Table of Contents
Advertisement
Problems encountered during installation
Unpacking
Description
Some parts appear to be missing or
damaged.
The SCSI cable shipped with the drive is not correct
Description
The SCSI cable shipped with the drive does
not plug into the SCSI host adapter of the
server.
The screws or mounting hardware are not suitable for the server
Description
Additional parts may be required for fitting
the tape drive into the server.
It is unclear which SCSI ID to use
Description
It is uncertain which ID numbers are
available.
How should the SCSI bus be configured?
Description
Correct configuration of the SCSI bus with
multiple drives can be a complex area and
more help may be required.
Further information
Contact your vendor if any parts need replacing.
Further information
The cable provided will connect to the majority of
systems. if a different cable is required, refer to the
www.hp.com/go/connect
Further information
The HP StorageWorks SDLT 600 internal tape drive
will fit into most servers without the need for
additional hardware other than that originally
shipped with your system. If additional parts are
required, or the original parts have been lost, contact
your server vendor. See "Step 4: Attach mounting
hardware" on page 15.
Further information
Use HP Library & Tape Tools (see page 33) to provide
information on your current SCSI settings. You can
also normally check the SCSI configuration from the
boot-up screen or from the Windows Control Panel
The HP StorageWorks SDLT 600 drive has its SCSI ID
set to 6 by default. This should be left unchanged
unless this number is already in use. Full instructions
on how to change the SCSI ID are given on
page 11page 11.
Further information
Refer to the "SCSI Configuration" section in the online
User's Guide on the HP StorageWorks Tape
CD-ROM.
web site.
37
Advertisement
Table of Contents
