Desa SBVBN(C) Owner's Operation And Installation Manual page 18

CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION
18
Installing Logs, Lava Rock, and Glowing Embers
CAST IRON STOVE AND
B-VENT BURNER SYSTEM
INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK, AND
GLOWING EMBERS
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this burner system may result
in property damage or personal injury.
It is very important to install these logs exactly as instructed in
Figures 43 through 47 . Do not modify logs. Only use logs supplied
with freestanding burner system. Do not use if any log(s) are broken
(see Replacement Parts, page 26).
1. Remove glass door. See Removing/Replacing Glass Door,
page 17.
2. Place log #1 (back log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 43).
2. Rest log #2 (large front log) on the pins on the front part of the grate
(see Figure 44).
3. Place log #3 (crossover log) onto the rear and front logs. Make
sure it is seated properly into the notch on the front log and
over the raised triangular portion of the rear log as shown in
Figure 45.
4. Place log #4 (small log) onto the front left part of the grate making
sure the notches fits over the prong of the grate. See Figure 46.
5. Lava rock may be placed along sides and front inside burner
system bottom. This may not be visible when you have re-
placed the front of the stove. It is not necessary to use all of
the lava rock provided.
Figure 43 - Installing Log No. 1
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Figure 44 - Installing Log
No. 2
NOTICE: Do not put lava rock on burner or under
burner. Placing lava rock on burner could cause
performance problems.
6. Pull ember material apart into pieces no larger than a dime.
Place these pieces loosely and sparingly directly onto the ex-
posed section of the front burner and along the space between
the burner and grate prongs (see Figure 47). This will create
the glowing ember appearance as the flame touches the ember
material. Do not block air slots by using too much ember ma-
terial in one area. It is not necessary to use all of the ember
material provided.
7. Replace the glass door and stove front. See Removing/Re-
placing Glass Door, page 17.
WARNING: The glass door must be securely in
place before running this burner system. Do not run
this burner system if glass is missing or broken.
Figure 45 - Installing Log No. 3
Figure 47 - Placing Ember Material on Burner
Figure 46 - Installing Log
No. 4
106828-01C