Desa SBVBN(C) Owner's Operation And Installation Manual page 16

CAST IRON STOVE AND B-VENT BURNER SYSTEM INSTALLATION
16
Installing Optional Wall Mounted Thermostat - GWMT1 (Cont.)
Installing Optional Wireless Hand-Held Remote Control Accessories - GHRCB and GHRCTB Series
CAST IRON STOVE AND
B-VENT BURNER SYSTEM
INSTALLATION
Continued
4. Route the wire to a convenient location to mount your thermo-
stat (no outside wall). IMPORTANT: The wire must not ex-
ceed 25 feet in length.
The thermostat should be mounted 54" above the floor in a
location where there is good air circulation. Avoid heat sources
such as lamps, direct sunlight, fireplace, or heat and air con-
ditioning ducts.
5. Gently remove the cover of the thermostat from the base. Grasp
the sides of the cover firmly and pull to separate from the base.
6. Feed the electrical wires through the rectangular slots (from
the back) on each side of the base (see Figure 35).
7. Connect one bare wire end to each terminal ("W" and "R") of
the thermostat base (see Figure 36).
8. Install the base to the wall with screws provided with thermostat.
9. Move the temperature adjustment back and forth to insure the
bi-metal is free from restrictions.
WARNING: Do not connect this thermostat to a
power source. Electrical shock and/or fire hazard will
occur.
Feed wires through
rectangular slots
Figure 35 - Back View of
Thermostat Base
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Terminal
"W"
W
Terminal
"R"
R
Figure 36 - Thermostat
Base Terminal "W" and "R"
INSTALLING OPTIONAL WIRELESS HAND-
HELD REMOTE CONTROL ACCESSORIES -
GHRCB AND GHRCTB SERIES
Installing Remote Receiver
1. Open bottom door on stove body.
2. Disconnect wires from THTP and TH on control valve that
lead to the switch (see Figure 34, page 15). Discard switch
plate, screws, and nuts.
3. Install battery into receiver battery clip and connect to terminals
(see Figure 37).
4. Place receiver into valve bracket and align holes (see Figure 38).
5. Use push-in fasteners included with receiver to secure to
bracket.
6. Connect the wires from the receiver to the valve at TH and
THTP (see Figure 34, page 15).
Receiver
9-Volt
Battery
Figure 37 - Installing Battery in Receiver
Figure 38 - Installing Remote Receiver
Terminal
Wires
Battery Clip
106828-01C