Desa (F)SDVBNC Owner's Operation And Installation Manual page 7

CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
Stove Door
Panel
Door Hinge
Step Bolt
Bolt
Shoulder
Figure 11 - Attaching Lower Stove Door Panel
Door Claw
Door
Figure 12 - Catch Bolt and Door Claw Orientation
Stove
Body
Front
Assembly
Figure 13 - Removing Front Assembly
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107304
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Threaded
Hole
Bolt Stop
Adjusting Nut
Catch Bolt
Bolt
Stove Body Assembly (Cont.)
14. Lay the front panel assembly face down on a protected sur-
face. Remove the two screws that hold the front plate onto the
front surround plate (see Figure 14). Save these screws.
15. Remove the seven screws and washers that hold the
Optional:
screen onto the front surround plate. Discard these screws, wash-
ers, and screen. They are for vent-free use only (see Figure 14).
16. Replace the two screws from step 14 to reassemble the front
plate and the front surround plate. Set this assembly aside un-
til burner system has been installed, logs have been placed
inside of burner system, and glass door to burner system insert
has been replaced.
Front Surround
Plate
Screw with
Washer
Screen
Front Plate
Figure 14 - Removing Screen from Front Assembly
7 7
Screws