Pfaff HOBBY 1142 Manual page 17

Operate your hobby 1142 1:7
Thread through the hole in the bobbin (D)
from the inside to the outside as shown in
D
the picture.
Place the bobbin on the bobbin winder
spindle with the free end of the thread at
the top.
Push the bobbin to the right.
Note: The bobbin can only be wound when it
is moved fully to the right. Do not move the
bobbin winder spindle while the machine is
running.
Hold the end of the thread rmly and
press the foot control. Stop the machine
when the bobbin has made several turns,
and cut the free thread end close to the
bobbin.
Press the foot control again. When
the bobbin is fully wound, it will stop
automatically.
Push the bobbin to the left, remove it and
cut the thread.
Push in the handwheel to engage the
clutch.
Extra spool pin
If the machine is already threaded, you
can easily wind thread from the second
spool pin without unthreading the
machine.
Insert the extra spool pin into the hole (E).
Place the felt and a spool on the pin.
E
Thread the machine for winding in the
same way as before.