CHANGING NEEDLE REGULATING THE PRESSER FOOT PRESSURE 1. Push down inner pin (A) to increase pressure. (Light to medium fabrics) 2. Push down outer ring to release pressure. (Heavy fabrics) 3. Insufficient pressure may cause poor feeding, skipped stitches, or difficulty guiding the fabric.
TO START SEWING FABRIC THREAD NEEDLE TABLE Please note that the following list is a guide when sewing different fabrics. Important Hints 1. Raise the takeup lever to its highest position before starting and after stopping sewing. 2. Hold both threads about 10 cms to the rear of machine for the first two or three stitches.
BLflTON SEWING ZIPPER SEWING Select straight stitch. 1. ZIpper foot is designed to sow close to a raised edge preventing sowing on zipper 2. Place zipper foot In position and attach firmly 3. Fold the fabric about 2 cm and place fabric under foot 1 .Lower drop feed.
Page 13
Note: Hemmer foot can be purchased separately. HEMMING Note: Twin needle can be purchased separately TWIN NEEDLE 1. Raise the foot and the needle to its highest position. Replace the toot with the hemmer foot. 2. Fold over the fabric edge by about 3mm and place it under the foot. Secure the Take out the workpiece and draw the hem needle.
Page 14
Note: Quilt guide can be purchased separately. 1.MARK WITH A PENCIL OR CHALK THE EXACT LENGTH OF THE BUTTONHOLE ON THE FABRIC. 2. REMOVE THE REGULAR PRESSER FOOT AND ATTACH THE BUTTONHOLE FOOT & PUT THE FAE UNDER ThE BUTTONHOLE FOOT. 3.