Data; Troubleshooting - STEINEL NIGHTMATIC 3000 Operating Instructions

Technical data
Dimensions: (H x W x D) 99 x 74 x 37 mm
Connection: 230/240 V, 50 Hz
Switching capacity: max. 1000 watts (ohmic load, e.g. filament bulb)
max. 500 watts (fluorescent lamps, cos ϕ = 0.5)
Response threshold: adjustable from approx. 0.5 to 10 lux (factory adjustment 1 lux)
Night economy mode: variable switch-off at night (factory setting: off at approx. 1.30 a.m.)
Consumption: < 0.8 W
Enclosure: IP 54

Troubleshooting

Malfunction Cause
NightMatic 3000 Vario Fuse has blown, not
without power
switched ON, lead
disconnected
Short-circuit
Light fixture does not Consumer faulty
switch ON
No power supply
Surroundings still
too bright
Light fixture does not Surroundings not yet
switch OFF
sufficiently bright
Light fixture does not Function not properly
switch ON in the morning
activated
Light fixture switches ON Switchover from summer
at an unusual time
to winter time
Incorrectly calculated
switching times
8
Remedy
Replace fuse, switch ON
mains switch, check
wiring with voltage tester
Check connections
Change consumer
Refer to "NightMatic 3000
Vario without power"
Wait until switching
brightness is achieved. Set
a new switching value, if
required, using the button
Wait until sufficient
brightness achieved. Set
a new switching value, if
required (in the evening)
Adjust function according
to the section entitled
"Setting for the morning
hours"
Switching times are geared
to brightness values. Adjust
setting if required.
Readjust switching value
(switching times are re-
determined)
Declaration of conformity
This product complies with Low-Voltage Appliances,
the European Directive on 73/23/EEC and the EMC
Functional Warranty
This STEINEL product has This warranty shall not cover
been manufactured with damage to wearing parts or
great care, and its operation damage and faults caused
and safety have been tested by incorrect operation or
in conformity with the cur- maintenance. Breakage due
rent regulations. Production to a fall is also not covered.
is also submitted to final
Further consequential
random-sample testing.
damage to external items
The warranty period is is excluded.
36 months, starting on the
Claims under warranty shall
date of sale to the user. We
only be accepted if the pro-
undertake to remedy faults
duct is sent fully assembled
caused by material or ma-
and well packed complete
nufacturing defects. This
with sales slip or invoice
warranty undertaking shall
(date of purchase and dea-
be performed by the repair
ler's stamp) to the appro-
or replacement of the
priate Service Centre or
defective parts, at our own
handed in to the dealer
discretion.
within the first 6 months.
Directive 89/336/EEC.
Repair Service:
Our Customer Service
Department will repair faults
not covered by warranty or
after the warranty period.
Please send the product
well packed to your nearest
Service Centre.
9