Biostar TPOWER X58 Setup Manual page 37

<Auto Over-clock>
By this function, the utility will set the best and stable performance and
frequency automatically.
Click on then a Warning dialog will
show. This dialog tells that all running
applications should be closed before the auto
over-clock procedure. The utility will do a
series of test continually; do not do any
operation during the test procedure. Click OK
to proceed or Cancel to stop.
For getting the best performance, the utility will repeat the test continually until the system
hang or fail, and then the system will auto-reboot. After that, launch the T-Power2 and enter
the OC Tweaker again, you will find the setting has been restored to a safest and best
performance status. Save this setting is recommended.
<Manual Over-clock>
To manually adjust the clock and voltage, just click the
number. (For V-Ranger powered VGA card, click
beside the VGA values will show.)
the supplied value is recommended. If the test passes, following dialog will
show; click OK to proceed.
TPower X58/TPower X58A
After proceeding the tests would start, and a
warning message would continually show
telling that do not do any action to interfere
the testing procedure. The testing
procedure takes minutes; you can stop the
procedure by clicking Cancel.
then the
After the adjustment, click
or beside the
to verify
35