Biostar TPOWER X58 Setup Manual page 31

B. Memory Integration Test (M.I.T.)
This function is under "Overclocking Navigator Engine" item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is "Disabled"; the condition parameter should
be changed to "Enable" to proceed this test.
Main Advanced
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
Current QPI Frequency
Current Memory Frequency
Current Uncore Frequency
Intel(R) SpeedStep(tm) tech
Ratio CMOS Setting
CPU Frequency Setting
QPI Links Speed
QPI Frequency
Uncore Frequency
DRAM Frequency
Command Rate
> Intel PPM/Turbo Mode Configuraiton
> DRAM Timing Configuration
> Clock Gen Configuration
> Voltage Control
Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Main Advanced
=========== Automate OverClock System ===========
Auto OverClock System
============ Manual OverClock System ============
Current QPI Frequency
Current Memory Frequency
Current Uncore Frequency
Intel(R) SpeedStep(tm) tech
Ratio CMOS Setting
CPU Frequency Setting
QPI Links Speed
QPI Frequency
Uncore Frequency
DRAM Frequency
Command Rate
> Intel PPM/Turbo Mode Configuraiton
> DRAM Timing Configuration
> Clock Gen Configuration
> Voltage Control
Memory Test
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from "Enable" to "Disable"
to complete the test.
TPower X58/TPower X58A
BIOS SETUP UTILITY
PCIPnP Boot
Chipset
[V6-Tech Engine]
:
:
:
[Enabled]
[24]
[133]
[Full-Speed]
[4.800GT]
[Auto]
[Auto]
[Auto]
[Disabled]
↓
BIOS SETUP UTILITY
PCIPnP Boot
Chipset
[V6-Tech Engine]
:
:
:
[Enabled]
[24]
[133]
[Full-Speed]
[4.800GT]
[Auto]
[Auto]
[Auto]
[Enabled]
O.N.E Exit
Options
Disabled
Enabled
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
O.N.E Exit
Options
Disabled
Enabled
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
29