Installing The Cable-Management Arm; Figure 1-8. Installing The Cable-Management Arm - Dell PowerVault 50F Installation And Troubleshooting Manual
Dell powervault 51f 8-port fibre channel switch installation and troubleshooting guide
Hide thumbs
Also See for PowerVault 50F:
- Installation and troubleshooting manual (172 pages) ,
- User manual (42 pages) ,
- Rack installation manual (28 pages)
Table of Contents
Advertisement
support.dell.com
Installing the Cable-Management Arm
1.
From the back of the rack, pull the switch out about 7 centimeters (cm) (about
3 inches).
The switch should lock in place.
2.
Attach the end of the cable-management arm to the inner rail by inserting the
two T-tabs into the two T- slots until the retaining clip snaps into place (see
Figure 1-8).
T-slots
inner rail
T-tabs
retaining clip
Figure 1-8. Installing the Cable-Management Arm
cable-management arm
safety release latch
Installing the Dell PowerVault 51F Switch
Velcro strips
thumbscrew
1-11
Advertisement
Table of Contents
