Manual Lighting - Desa LMFP33NR(B) Owner's Operation And Installation Manual

OPERATING HEATER
Continued
1. STOP! Read the safety information on
page 19.
2. Make sure equipment shutoff valve is fully
open.
3. Set remote selector switch in the AUTO
position (see Figure 31).
4. Press in and turn control knob clockwise
to the OFF position (see Figure 31).
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the
safety information on page 20. If you don't
smell gas, go to the next step.
6. Press in and turn control knob counter-
clockwise
Press in control knob for five (5) seconds
(see Figure 34).
Note: You may be running this heater for
the first time after hooking up to gas sup-
ply. If so, the control knob may need to be
pressed in for 30 seconds or more. This will
allow air to bleed from the gas system.
7. With control knob pressed in, press and
release ignitor button. This will light pilot.
The pilot is attached to the rear of the front
burner. If needed, keep pressing ignitor
button until pilot lights.
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier for
repairs. Until repairs are made, light pilot
with match. To light pilot with match, see
Manual Lighting Procedure.
8. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when
released, contact a qualified service person
or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
Ignitor Button
Control Knob
Remote Selector
Switch
Figure 31 - Remote Selector Switch,
Control Knob and Ignitor Button
20
to the PILOT position.
AUTO MAN
www.desatech.com
9. Slightly push in and turn control knob coun-
terclockwise
10. Press the on/off key on the remote control
to turn on appliance main burner. Wait at
least 5 seconds before setting desired flame
height.
11. Press the up or down key until the small
triangle is to the left of large flame icon
at the top of LCD display (see Figure 36,
page 22). Press the left or right key to set
the desired flame height.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
Pilot Burner
Figure 32 - Pilot (Propane/LP)
Pilot Burner
Figure 33 - Pilot (Natural)
TO TURN OFF GAS
TO AppLIANCE
Shutting Off Heater
Press on/off key on remote control and turn
control knob clockwise
tion (see Figure 31).
Shutting Off Burners Only (pilot stays lit)
Press the on/off key on remote control or turn
control knob clockwise
position.

MANUAL LIGHTING

pROCEDURE
1. Follow steps 1 through 7 under Lighting
Instructions, column 1.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions.
to the ON position.
Ignitor
Electrode
Ignitor
Electrode
to the OFF posi-
to the PILOT
119526-01A