Table of Contents
Advertisement
OPERATING
FIREPLACE
Continued
WARNING: Make sure the re-
mote selector switch is in the
OFF position when you are away
from home for long periods of
time. Heater will come on auto-
matically with remote selector
switch in the ON position.
Pilot Burner
Figure 27- Pilot
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
to the OFF position.
2. Set remote selector switch in the OFF
position.
Shutting Off Burners Only (pilot
stays lit)
You may shut off the burners and keep
the pilot lit by doing one of the following:
• Turn control knob clockwise
to the PILOT position.
• Use remote control manual OFF button.
• Set remote selector switch in the OFF
position.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Light-
ing Instructions, pages 14 and 15.
2. Depress control knob and light pilot
with match.
3. Keep control knob pressed in for 30
seconds after lighting pilot. After 30
seconds, release control knob. Now
follow step 9, column 3, page 14.
104353
OPTIONAL REMOTE
Note: All remote control accessories must
be purchased separately (see Accessories,
page 21). Follow instructions included
with the remote control.
Thermostat Control Operation
(Optional GHRCT Only) The thermo-
stat control setting on the remote control
unit can be set to any comfort level be-
tween HI and LO. The Burners will turn
on and off automatically to maintain the
Ignitor
comfort level you select. The ideal com-
Electrode
fort setting will vary by household de-
pending upon the amount of space to be
heated, the output of the central heating
system, etc.
For wall thermostat operation, follow in-
struction supplied with thermostat ac-
cessory GWMT1. For wall switch opera-
tion follow instructions supplied with
GWMS2.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 14.
Flame Adjustment Knob
Control Knob in
On Position
Figure 28 - Setting the Remote Selector Switch, Control Knob, and
Flame Adjustment Knob for Remote Operation
Shows Temperature
Setting
Allows Burners to be
Turned On and Off
with the Hand-Held
Remote Unit.
The log heater will
automatically cycle
between pilot and the
heat setting that has
been selected.
Figure 29 - Thermostat Hand-Held Remote Control Unit Selections
OWNER'S MANUAL
OPERATION
Remote Selector Switch in Remote
Position(Optional Remote Control)
HI
TEMP
LO
MAN
ON
AUTO
OFF
STATUS
15
1.
After lighting, let pilot flame burn for
about one minute. Turn control knob
to ON position. Adjust flame adjust-
ment knob anywhere between HI
and LO. Slide the remote selector
switch to the REMOTE position (see
Figure 27). The burners will come on.
You can now turn the burners on and
off with the hand-held remote con-
trol unit.
IMPORTANT: Do not leave the re-
mote selector switch in the REMOTE
position when the pilot is not lit. This
will drain the battery.
GHRC Operation:
2.
Press the ON button to turn the burn-
ers on and the Off button to turn the
heater to pilot.
GHRCT Operation:
2.
Select the MANUAL or AUTO but-
ton on the hand-held remote control
unit (GHRCT only, see Figure 28).
• In MANUAL mode, turn burners
on or off by pressing the ON or
OFF buttons on the hand-held re-
mote control unit. This is the only
function of GHRC.
ON
OFF
REMOTE
Increases Room
Temperature
Decreases Room
Temperature
Turns Burners
On and Off
Shows Current
Operation Mode
Continued
Advertisement
Table of Contents
