Installing Logs; Installing Screen - Desa Comfort Glow LFP33PRA Owner's Operation And Installation Manual

INSTALLATION
Continued

INSTALLING LOGS

WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
WARNING: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 22). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner "U" bend.
2. Locate pegs on the bottom of back log
(#2). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 23).
3. Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 24).
4. Place crossover log (#4) onto the pin (right)
on back log (#2) and into the recess of the
middle log (#1) (see Figure 25).
107064
Middle Log (#1)
"U"-shaped
Cutout in
Base
Figure 22 - Installing Middle Log (#1)
Peg
Hole in Base
Figure 23 - Installing Back Log (#2)
Front Log (#3)
Notches
Grate Fingers
Figure 24 - Installing Front Log (#3)
13
OWNER'S MANUAL
Crossover Log (#4)
Burner
Figure 25 - Installing Crossover Log (#4)

INSTALLING SCREEN

Back Log (#2)
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Peg
Install fireplace screen by slipping notches
of fireplace screen over screws on front of
fireplace (see Figure 26).
Notches
Figure 26 - Installing Fireplace Screen
Peg
Recess
Screws for
Mounting Screen
Continued