Installing Logs - Desa A Series Owner's Operation And Installation Manual

Unvented (vent-free) propane/lp gas fireplace, variable manuallycontrolled "a" models and thermostaticallycontrolled “c” models with split oak logs
Table of Contents

Advertisement

DESA INTERNATIONAL
UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued

INSTALLING LOGS

WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Place front log (#1) on top of the grate.
Make sure the notches in the bottom of
the log fit over the grate prongs (see
Figure 35). Push back of log flush with
metal grate bar.
2. Rest middle log (#2) behind metal posts
on front burner. Make sure the grooves
in the bottom of the log fit over the grate
(see Figure 36). Bring the log forward
next to the metal posts.
3. Slide the grooves in the back of the rear
log (#3) against the rear grate prongs.
Make sure the peg on the log is on top
(see Figure 37).
4. Place the crossover log (#4) on the rear
log and the middle log. Make sure the
peg on the rear log is in the hole in the
bottom of the crossover log. The cross-
over log should fit in the cutout of the
middle log (see Figure 38).
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
5. Install fireplace screen by slipping
notches of fireplace screen over screws
on front of fireplace (see Figure 39).
Front Log (#1)
Notch
Grate
Prongs
Metal Grate Bar
Figure 35 - Installing Front Log (#1)
Middle Log (#2)
Groove
Metal Post
Groove
Metal Post
Figure 36 - Installing Middle Log (#2)
Peg
Groove
in Back
of Log
Grate
Prong
Rear
Burner
Figure 37 - Installing Rear Log (#3)
16
Cutout
Figure 38 - Installing Crossover Log (#4)
Grate
Notches
Rear Log (#3)
Groove
in Back
Figure 39 - Installing Fireplace Screen
of Log
Grate
Prong
Crossover
Log (#4)
Hole
Peg
Screws for
Mounting Screen
104410

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

C seriesVsgf28pvaVsgf28ptcCsgf28ptc

Table of Contents