Installation - Desa AND VM42 Owner's Operation And Installation Manual

B-vent decorative gas fireplace
Table of Contents

Advertisement

INSTALLATION

WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas
control valve without the normal household electricity since the
valve operates on millivolt current supplied by the heat generated by
the thermopile. To install the wall switch:
1. Remove the front refractory access panel by lifting up and an-
gling out of the firebox opening (see Figure 13).
2. Use wire and connectors provided. Attach red wire to terminal
marked TH/TP on control valve. Attach white wire to blade
connector on open end of safety circuit wiring (see Wiring
Diagram, page 20).
Note: If any of the original wire from the unit control must be replaced,
use the same type or a higher rated wire (25 ft. maximum length).
WARNING: Do not wire remote wall switch to main
power supply (Standard 120v household current).
4. Locate wall switch in a convenient location.
5. After wire connections are complete, replace refractory access
panel.
Figure 13 - Removing Front Refractory Access Panel
108795-01K
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Optional Wireless Hand-Held Remote Control Installation
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL INSTALLATION
Note: If using optional wireless hand-held remote control, the wall
switch is no longer operational.
Installing Receiver
1. Remove the front refractory access panel by lifting up and
angling out of the firebox opening (see Figure 13) to expose
controls.
2. Disconnect wall switch wires from TH and TH/TP terminals
on control valve (see Figure 14).
3. Install remote receiver unit onto mounting bracket using the
two plastic mounting clips (see Figure 15).
Note: If any of the original wire as supplied must be replaced, use
18 AWG TYPE CL2 (UL) 105 C (25 ft. length MAXIMUM) or
equivalent.
Figure 14 - Wall Switch Wiring Diagram
Receiver
Figure 15 - Installing Remote Receiver (Shown from Rear of
Mounting Bracket)
INSTALLATION
Wall Switch Installation
Route Millivolt
To Safety Circuit
Wires (Supplied)
Through Gas Line
Conduit Sleeve
To Thermopile
Plastic
Mounting
Clips
Mounting
Bracket
11
11
Wall Switch
(Supplied)
(Back View)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents