Table of Contents
Advertisement
Chapter 2 Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed as below:
1.
Locate an available CardBus slot on your laptop.
2.
With the connector pin end facing the CardBus slot and the label facing up, slide the
Adapter into the CardBus slot until it locks in place.
Note:
Once the Adapter is firmly in place, the Found New Hardware Wizard screen will pop up.
2.2 Software Installation
2.2.1 Overview
The Adapter's Setup Wizard will guide you through the Installation procedure for Windows 2000,
XP and Vista. The Setup Wizard will install the TP-LINK Wireless N Client Utility (11NWCU) and
drivers.
When you install the hardware prior to before installing the software, the system will prompt
"Found New Hardware Wizard", click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000, XP and Vista are very similar. The following setup steps
are for Windows XP.
2.2.2 Software Installation for Windows XP
1.
Insert the Resource CD into your CD-ROM drive, and open the folder with the same name
as your product. Then double-click Setup.exe in the proper folder according to your
operating system to start the installation. After that, Figure 2-1 will appear. You can click
Cancel to end the installation in the screen above.
TL-WN910N
Wireless N CardBus Adapter
4
Advertisement
Table of Contents
