Maintaining Your System; Replacing The Remote Control Battery - Bose Acoustic Wave CD3000 Owner's Manual

Replacing the remote control battery

Figure 12
Pressing the (a) tab lock
down to remove the (b) bat-
tery compartment
If your remote control does not work properly, or its range of operation is reduced, it is time to
replace the battery. Follow the instructions below:
1. Place the remote control face down on a flat surface.
2. Press the tab lock on the battery compartment to the side, as shown (Figure 12a).
3. Hold that tab down as you slide the battery compartment open and remove the battery.
4. Install a new battery, making sure that the positive symbol (+) is facing up as you put the
battery into the compartment (Figure 12b).
(a)
WARNING: Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
Replace only with a lithium CR2032 or DL2032 battery by Duracell, Eveready, Hitachi, Maxell,
or Toshiba (available from most electronics stores).
Mishandling the remote control battery may cause a fire or chemical burn. Keep the battery
away from children. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate the
battery. Dispose of the used battery promptly and responsibly.
For more information, call Bose
back cover of this guide.

Maintaining Your System

(b)
Tab
® customer service. Refer to the phone numbers on the inside
Positive symbol
15