Kenmore 3247 - Elite 36 in. Gas Cooktop Installation Instructions Manual page 5

Typical Under Counter Installation of an Electric Built-in
Oven with a Cooktop Mounted Above
All mounting hardware
must be used to secure
the built-in oven to the
cabinets. Refer to the
built-in oven installa-
tion instructions.
Junction box must
be located approx.
3" to the left of
the built-in oven
cutout,
208/240 Volt grounded junction
box for built-in
This cooktop may
be installed over
certain built-in elec-
tric oven models.
Side filler panels are necessary to
isolate the unit from adjoining
cabinets. Panel height should allow
for installation of approved cooktop
models. See "Typical Gas Cooktop
Installation Over an Electric Built-in
Oven Installed Under the Counter"
on previous page.
32" Min.**
(81.3 cm)
36"
(91.4 cm)
Use 3/4" (1.9 cm) plywood, installed
on two runners, flush with toe plate.
Must be capable of supporting 150 Ibs.
Cut an opening in wood base minimum 9"
(22.9 cm) x 9" (22.9 cm), 2" (5.1 cm) from
left side filler panel, to route armoured
cable to junction box.
4 1/2" (11.4 cm)
Max.*
* If no cooktop is installed directly
over the oven unit, 5" (12.7 cm)
maximum is allowed.
** 32" (81.3 cm) min. from top of
cabinet to top of runners must be
maintained.
CUTOUT DIMENSIONS (inches)
OVEN SIZE E F G
Min. Max, Min. Max.
30" 27¼" 28s/8 '' 281/2" 29" 231/2"
(76.2 cm) (69.2 cm) - (72.7 cm) (72.4cm) - (73.7 cm) (59.7 cm)
27" 27¼" 28s/8 '' 247/8 '' 25¼" 231/2"
(68.6cm) (69.2cm) - (72.7cm) (63.1cm) (64.1cm) (59.7cm)