Advertisement
Available languages
Available languages
Quick Links
_NSTALLAT_ON AND SERVICE MUST BE PERFORMED BY A QUAUF_ED
INSTALLER.
_MPORTANT: SAVE FOR LOCAL ELECTRICAL _NSPECTOR'S USE.
READ AND SAVE THESE _NSTRUCT_ONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasotine or other flammabte
vapors and tiquids in
the vicinity
of this or any other appliance.
IMPORTANT INSTALLATION INFORMATION
All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC only
electrical supply with ground.
Minimum distance between cooktop and overhead cabinetry is 30" (76.2 cm).
For Standard Installation:
Cooktop Dimensions
30" Min. *
(76.2 cm)
* 30" (76.2 cm) rain. for
unprotected cabinet and
24" (6! cm) rain. for
cabinet with protected
bottom surface.
Cooktop Cutout Dimensions
C
4"X 8" (!0.2 cmx 20.3 cm)
openin
to route armoured cable.
(89.2 cm)
Do not stide unit into cabinet cutout.
Protruding
screws on the bottom
of
unit may damage the bottom
front
finish.
Figure 1
**Note:
D & E are critical to the proper installation
of the cooktop. D reflects the finished dimension.
Due to the variation in countertop materials, it is
recommended to first undercut this dimension, and
then
adiust
it upon installation of the cooktop.
All dimensions are stated in inches and (cm).
Allow 2" (5 cm) space below the armoured cable opening to clear tile electric cable and
allow space for installation of tile junction box on the wall at the back of the cooktop.
P/N 318201418
(0407)
Rev A
EngU-_ - pages 1-6
Espa_iol-
pages 7-12
Advertisement
Related Manuals for Kenmore 318201418
Summary of Contents for Kenmore 318201418
- Page 1 Figure 1 All dimensions are stated in inches and (cm). P/N 318201418 (0407) Rev A Allow 2" (5 cm) space below the armoured cable opening to clear tile electric cable and EngU-_ - pages 1-6 allow space for installation of tile junction box on the wall at the back of the cooktop.
- Page 2 For Installation with the optional Stainless Steel Backsplash. * 30" (76.2 cm) rain. for unprotected cabinet and 24" (61 cm) rain. for cabinet with protected bottom surface. 30"(7( 2 cm) Min.* Cooktop Dimensions 2"(5.1 cm) ***Note: Applies only in 4"X 8" (10.2 cm x 20.3 cm) case of countertop j*** backwall.
- Page 3 Overhead Cabinet Should Not Exceed a Maximum Depth of 13" (33 cm) 30" (76,2 cm) Min, It is not recommended to use Clearance Between the drawer underneath cooktop Top of the Cooking Platform and the Bottom 10" of an Unprotected Wood Combustible Surface or Metal Cabinet...
-
Page 4: Important Notes To The Installer
Important Notes to the Installer Electrical Requirements 1. Read allinstructions contained i nthese installation Observe all governing codes and local ordinances. instructions before installing t hecooktop. A 3-wire or 4-wire single phase 120/240 or 120/208 2. Remove allpacking material before connecting the Volt, 60 Hz AC only electrical supply is required on a electrical supply tothecooktop. - Page 5 Where local codes permit connecting the appliance- Emectrica[ Connection grounding conductor to the neutraJ (white) wire Connect the flexible armored cable that extends from (see figure the surface unit to the junction box using a suitable strain relief at the point the armored cable enters the 1.
- Page 6 If cooktop is used in a new branch circuit Cooktop Installation installation (!995 NEC), mobile home, recreational 1. Visually inspect the cooktop for damage. vehkle, or where toca! codes DO NOT permit 2. If you are installing the optional Stainless Steel backsplash, first fix it at the back of the cooktop using grounding through...
- Page 7 22(ss,% I1v_<2.%Max. 7V_<I%I> j Todas las dimensiones se dan en pulgadas (cm), P/N 318201418 (0407) Rev A Deje un espacio de 2 pulgadas (5 cm,) debajo de la abertura del cable bJindado para hacer pasar el English - pages 1-6 cable eJectrico y deje espacio para instaJar Jacaja de juntas en Japared detr_is de la cocina, Espa¢_ol- p3ginas...
- Page 8 Para v erlaInstalaci6n conelPanel Protector Opcional deAcero Inoxidable, * 30" (76.2 cm) min. para un gabinete desprotegido. 24" (61 cm) min. para una superficie protegida. Dimensiones de la Estufa 2"(5.1 cm)_ Panel Protector de Acero hoxidable 9" (22,9 cm) ***Nota: Se aplica solamente en caso que tenga un mostrador con parte posterior.
- Page 9 El armario superior no debe sobrepasar profundidad maxima de 13" (33 cm) No es recomendable utilizar cajones debajo de la estufa_ parte inferior del armario madera o metal esta rotegida por una plata cortafuego retardante de llama de no menos de I/4", cubierta una kimina...
- Page 10 Notas importantes para el instalador Requisitos el_ctricos Lea todas las instrucciones contenidas en este manual (utopia con todos los c6digos en vigor y todos los antes de instalar la estufa. regJamentos locales. Para el suministro el_ctrico solamente se necesita Saque todo el material usado en el embalaje de la estufa antes de conectar el suministro electrico a la corriente con frecuencia de 60 Hz AC y fase 0nica de estufa.
- Page 11 Conexi6n E[_ctrica Donde Jos c6digos JocaJes permitan conectar el conductor de puesta a tierra de1 eJ_ctrodom_stico Conecte el cable b[indado flexible que se extiende desde neutral (bJanco) (vet figura 4): la superficie del artefacto hasta la caja de empalmes Desconecte el suministro el_ctrico. utilizando una grapa de alivio de tensi6n adecuada en el punto en que el (:able blindado entra en la caja de En el interruptor automatico, caja de fusibles o caja de...
- Page 12 Si la cocina se usa en una instalaci6n nueva de ramal Instalacion de la Tapa de Cocina de circuito (1996 NEC), en una casa rodante, en un 1. Inspeccione visualmente la tapa de la cocina para ver vehiculo para recreaci6n o si los c6digos locales NO siesta danada.