Inserting the Bobbin
Inserting the Bobbin
Insert the bobbin so that the thread winds
clockwise.
Threading the Upper Thread
A
Pulling the Thread Under the Spring
Pull the thread to the left under the spring
until it lies in the T-shaped slit at the end of
the spring.
Attaching the Thread Spool
• raise the needle and presser foot
• turn the power switch to «0» (off)
• attach the foam pad
• place spool on pin (thread winds clockwise)
• attach the appropriate spool disc -
diameter of spool determines disc size.
There must be no clearance between the
disc and the spool
• take thread through rear guide A
• then into slit of upper thread tension
!
Refer to the
safety instructions!
031196.50.04_0507_a630_EN
Operating Instructions
Clockwise Turning of the Bobbin
The bobbin must turn clockwise.
C
B
Down
• pull thread down to the right of the take-
up cover to B
Up
• take thread up to the left of the cover to C
in the direction of the arrow, placing it in
the take-up lever
Down
• take thread down and through guides D
and E
11
D
E