Brocade Communications Systems 8 Administrator's Manual page 32

2
QOS, DSCP, and VLANs
The following example creates an additional FCIP circuit with a different VLAN tag.
The following example shows a fcipcircuit modify command that changes the vlan tag and l2cos
levels for circuit 0. Parameters are the same for both the create and modify options.
The following example shows a fcipcircuit modify command that changes the DSCP values for
circuit 0. Parameters are the same for both the create and modify options.
The following example shows the use of the portshow command to display the tunnel and circuit
values. Use the -c option as shown to include circuit values.
18
switch:admin> portcfg fcipcircuit 16 create 1 192.168.2.21 192.168.2.11 100000
-v 200
Operation Succeeded
switch:admin> portcfg fcipcircuit 16 modify 0 -v 300 --l2cos-f-class 7
--l2cos-high 5 --l2cos-medium 3 --l2cos-low 1
!!!! WARNING !!!!
Modify operation can disrupt the traffic on the fcipcircuit specified for a
brief period of time. This operation will bring the existing circuit down (if
circuit is up) before applying new configuration.
Continue with Modification (Y,y,N,n): [ n]
Operation Succeeded
switch:admin> portcfg fcipcircuit 16 modify 0 --dscp-f 32 --dscp-h 16 --dscp-m
8 --dscp-l 4
Operation Succeeded
switch:admin> portshow fciptunnel 16 -c
-------------------------------------------
Tunnel ID: 16
Tunnel Description:
Admin Status: Enabled
Oper Status: In Progress
Compression: Off
Fastwrite: Off
Tape Acceleration: Off
TPerf Option: Off
IPSec: Disabled
Remote WWN: Not Configured
Local WWN: 10:00:00:05:1e:c3:f0:16
Peer WWN: 00:00:00:00:00:00:00:00
Circuit Count: 2
Flags: 0x00000000
FICON: Off
-------------------------------------------
Circuit ID: 16.0
Circuit Num: 0
Admin Status: Enabled
Oper Status: In Progress
Remote IP: 192.168.2.20
Local IP: 192.168.2.10
Metric: 0
Min Comm Rt: 100000
Max Comm Rt: 100000
SACK: On
Min Retrans Time: 100
Max Retransmits: 8
y
Fabric OS FCIP Administrator's Guide
53-1001766-01