Appendix A
Replacing Memory Components
Insert the new SDRAM DIMM by sliding the end with the metal fingers into the DIMM socket. (See
Step 9
Figure
Figure A-6
Snap the latches into place. Do not use excessive force because the socket might break.
Step 10
Replace the chassis cover. (See the
Step 11
Replace the feature cards. (Refer to the Cisco AS5350 and Cisco AS5400 Universal Gateway Card
Step 12
Installation Guide for instructions on replacing specific dial feature cards.)
Power ON the universal gateway. If error messages relating to memory are displayed, remove the
Step 13
SDRAM DIMM and reinstall it, taking care to seat the DIMM firmly in its socket.
Replacing Flash Memory SIMMs
The system card contains three sockets for flash memory SIMMs (see
•
•
OL-2847-02 0A
A-6.)
Inserting the New SDRAM DIMM into the Socket
Two sockets hold SIMMs containing the Cisco IOS software image. Each SIMM is 32 MB.
Cisco recommends that you first install SIMM0. To increase the memory capacity to 64 MB, install
the second SIMM in SIMM1.
"Replacing the Chassis Cover"
Cisco AS5400 Universal Gateway Chassis Installation Guide
Replacing Flash Memory SIMMs
section on page A-13.)
Figure
A-4):
A-9