JVC VN-A1U - Network Encoder Instructions Manual page 33

In Alarm 1, Alarm 2 and Motion
Detection, select OFF or ON for the
input to each terminal. When ON is
selected, also check the Alarm Output
if the alarm signal should be output.
CAUTION
When Relay Alarm is set, following alarm operations will not activate.
Example: If relay alarm is generated in the order of Alarm 1 ➝ Alarm 2, the
operating mode becomes: Operation of Alarm 1 ➝ Operation of relay alarm. The
operation of Alarm 2 itself will not be executed.
In Relay Alarm setup to set an alarm
or motion detection input received after
an Alarm 1, Alarm 2 or motion detection
input has been received, to be identified
as an interlocked alarm.
Check Use Relay Alarm and specify the
alarm occurrence sequence and the
time interval between alarms. If the
alarm signal is to be output in the case
of an interlocked alarm, check the Alarm
Output checkbox.
33