JVC VN-A1U - Network Encoder Instructions Manual page 24

6. Setup of the V.Networks Setup Tool
When installation is completed, select Start - Program - V.NETWORKS to
invoke the VN-A1U Setup Tool.
Change to the IP
address assigned or
approved by the
network
administrator.
(192. 168. 0. 2 is
used as an example
in the diagram.)
Enter a value
suitable for the
setting operation.
If a suitable value
is not known,
check with the
network
administrator.
The VN-A1U ID
corresponds to the
identification code located
on the VN-A1U body. Only
alphanumerics can be
entered.
The user does not
participate directly.
Normally, consecutive
numbers such as
CAM00001, CAM00002.....
will be set.
24
Enter the IP address of the VN-A1U to be
set up.
The factory-set IP address is: 192.168.0.2
Click to set up the motion
detection operation.
For the alarm
settings, see
page 32.
For setting of the password
setup, see page 37.
Settings are updated at the
time when OK is clicked.
Click to display
the Compact
Flash information.
Click to set the time
for the VN-A1U.
Click to set the
FTP function.
Click to set the
function for
recording in
Compact Flash.