Operation - Technics SU-700 Operating Instructions Manual

Adjust tone quality as desired. Set to the "on" to the "on" position when
Operation
• ....'UIU."
the left/right volume balance.
While listening to an AM broadcast or a monaural FM broadcast, balance
the sound so that it seems to be heard from the center, between the
1
Power: "on" (.~ ....)
Before turning the power on, make sure the volume
control is set to the low position.
2
Select speaker systems to
be used.
3
"sou ree" (.... ~.)
To listen to tape set to the "tape 1/tape 1"'2" or
"tape 2/ext" :
If bath tape-monitor selectors are pressed at the
same time, only the sound Irom tape deck 2 will
be heard.
Low-range sound is adjusted with bass
control ("bass"), and high-range sound
with treble control ("treble").
4
Select the sound sou ree.
CD/aux:
Press this button to listen to equipment
connected to the "CDlAUX" terminal.
tuner:
Press this button to listen to radio
broadcasts.
phono:
Press this button 10 listen to phono
discs.
5
Follow the instructions accompanying your
equipment for set-up and operation of the
selected sound sou ree.
-
6
Adjust the volume
position to temporarily listening al low volume level.
reduce the volume level.
speakers.
When listening through headphones
Headphones If sound from speakers is not wanted,
(option) set the speaker
selectors to the "off" position.
Note:
Set volume control to minimum ("0")
position before
connecting headphones.
After listening is finished, power switches of all equipment
should be turned "olf".
1. Follow above steps 1 through 6.
2. Operation of tape deck connected to the "TAPE 1" and/or
"TAPE 2/EXT" terminals.
3. By using the controls on the tape deck, adjust the recording
level. Then begin recording.
By using two tape decks, tape-to-tape recording can be
performed.
To record from tape deck 1 to 2 (Recording is not possible from
2 to 1):
1. Left tape monitor selector .... "tape
1/tape
1"'2" (I .... )
Right tape-monitor selector. . . . . . . . . . .. "source" ( ........ I)
2. Make the adjustment of Ihe recording level by using the
controls on the tape deck 2.
3. Begin the tape deck 1 (TAPE 1) for playback and the tape
deck 2 (TAPE 2) lor recording.
6­