Propane construction heater heater size: 50,000 btu/hr (16 pages)
Summary of Contents for Desa RM50PVA
Page 1
EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE POI- SONING, AND/OR ELECTRICAL SHOCK. ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR SERVICE THIS HEATER. IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN INSTRUCTIONS MANUAL, LABELS, ETC. CONTACT THE MANUFACTURER. Model: RM50PVA...
50,000 BTU/HR PROPANE CONSTRUCTION HEATER SAFETY INFORMATION WARNINGS WARNING ICON G 001 WARNING: FIRE, BURN, IN- HALATION, AND EXPLOSION HAZARD. KEEP SOLID COMBUS- TIBLES, SUCH AS BUILDING MA- TERIALS, PAPER OR CARD- BOARD, A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE IN- STRUCTIONS.
PRODUCT IDENTIFICATION Hot Air Outlet (Front) Heater Base Piezo Ignitor Button Automatic Control Valve Knob Hose / Regulator Assembly Figure 1 - 50,000 BTU/Hr Model 105338 Shell Handle Motor Fan Guard Valve Power Inlet Cord OWNER’S MANUAL UNPACKING Remove all packing items applied to heater for shipment.
50,000 BTU/HR PROPANE CONSTRUCTION HEATER THEORY OF OPERATION THE FUEL SYSTEM The hose/regulator assembly attaches to the propane gas supply. This provides fuel to the heater. THE AIR SYSTEM The motor turns the fan. The fan pushes air into and around the combustion chamber. This air is heated and provides a stream of clean, hot air.
INSTALLATION WARNING: Review and un- derstand the warnings in the Safety Information section, page 2. They are needed to safely op- erate this heater. Follow all local codes when using this heater. WARNING: Test all gas pip- ing and connections for leaks after installation or servicing.
50,000 BTU/HR PROPANE CONSTRUCTION HEATER OPERATION WARNING: Review and un- derstand the warnings in the Safety Information section, page 2. They are needed to safely op- erate this heater. Follow all local codes when using this heater. TO START HEATER 1.
• Do not block the flow of com- bustion or ventilation air. TROUBLESHOOTING Note: For additional help, visit DESA International’s Technical Service web site at www.desatech.com. OBSERVED FAULT Fan does not turn when heater is plugged in.
50,000 BTU/HR PROPANE CONSTRUCTION HEATER SERVICE PROCEDURES You can also visit DESA International’s Technical Service site www.desatech.com. WARNING: Never service heater while it is plugged in, con- nected to propane supply, oper- ating, or hot. Severe burns and electrical shock can occur.
Page 9
SERVICE PROCEDURES Continued 1. Remove three screws that attach fan guard to heater shell. 2. Remove motor and fan guard from heater shell (see Figure 14). 3. Use hex wrench to loosen set screw that holds fan to motor shaft (see Figure 15). 4.
If they can not supply an accessory or part, either con- tact your nearest Parts Central (listed in the separate Authorized Service Center book- let) or contact DESA International for infor- mation. Part Number Description...
Should your heater require service, return it to your nearest authorized service center. Proof of purchase must be presented with the heater. The heater will be inspected. A defect may be caused by faulty materials or workmanship. If so, DESA International will repair or replace the heater without charge.