Sherwood RD-6502 Operating Instructions Manual page 15

When CD, VIDEO 1~2 is selected as an input source
.
4
Select the digital or the analog input
connected as desired.
or
• Each time this button is pressed, the corresponding
input is selected as follows:
� o(ptical) 1 � c(oaxial) 1 � c(oaxial) 2
A(nalog) �
�Notes :
• WhenTUNER, AUX 1~2, TAPE, EXTERNAL IN or
VIDEO 3 is selected as an input source, the analog
input is selected automatically.
• When the selected digital input is not connected,
the "DIGITAL" indicator flickers and the analog
input is automatically selected.
• The selected digital or analog input is automatically
assigned to the corresponding input source on the
INPUT setup menu. (For details, refer to "SETTING
THE INPUT " on page 32.)
• The sound from the component connected to the
selected digital input can be heard regardless of the
selected input source.
.
5
Operate the selected component for
playback.
• When playing back the program sources with
surround sound, refer to "ENJOYING SURROUND
SOUND" on page 17.
.
6
Adjust the (overall) volume.
or
DOWN UP
.
7
To mute the sound.
• "MUTE" will flicker.
• To resume the previous sound level, press it again.
.
8
To listen with the headphones.
• Ensure that the SPEAKER button is set to off.
• When listening to a DTS or Dolby Digital program
source, if the headphones are plugged in and the
SPEAKER button is set to off, it enters the 2CH
downmix mode automatically. (For details, refer to
"2 CH downmix mode"on page 18.)
• When the EXTERNAL IN is selected as an input
source, only front left and front right channel signals
can be reproduced through the headphones.
14