Protocol: Select the port number protocol type (TCP, UDP or both). If you are
unsure, then leave it to the default "both" setting. Public Port enters the
service (service/Internet application) port number from the Internet that will
be re-directed to the above Private IP address host in your LAN Network.
Public Port: Port number will be changed to Local Port when the packet enters your
LAN Network.
Fill in the "Description" , "Local IP", "Local Port", "Protocol" and "Public Port" of the
setting to be added and then click <Add> button. Then this Virtual Server setting will
be added into the "Current Port Forwarding Table" below. If you find any typo before
adding it and want to retype again, just click <Reset> and the fields will be cleared.
If you want to remove Port Forwarding settings from the "Current Port Forwarding
Table", select the Port Forwarding settings you want to remove in the table and then
click "Delete Selected". If you want to remove all Port Forwarding settings from the
table, just click the <Delete All> button. Click <Reset> will clear your current
selections.
Click <Apply> at the bottom of the screen to save the above configurations.
Add Port Forwarding
Remove Port Forwarding
66
www.encore-usa.com